Help > Using the web interface > External Devices > Door stations > Configuration of the relay
Configuration of the relay
Configuration of the relay
Select the relay to be configured.
Relays | Name
Name of the relay as under Relays (actuators).
*Further help under Relays (actuators)
Operating mode
Select an operating mode.
*Further help under Relays (actuators)
PBX is decisive (primary)
Available relays can be toggled without affecting the PBX. After a reboot of the PBX the last identifiable state of the relay is restored.
*Further help under Relays (actuators)
Off control
Swichtes off relays with the operating modes Light, Door opener, Alarm and PC relay after the specified switching duration. When switched off, the hold time of the relay will be used. The PBX does not actively switch off the relay.
*Further help under Relays (actuators)
Switching duration
Specifies after how many seconds the relay will be switched off. Possible entries: 0 to 6000 (0 only for manual relays). It can only be switched off after the set switching duration when off control is enabled.
*Further help under Relays (actuators)
Hold time
Specifies how many milliseconds the relay is held. Possible entries: 10 to 10000. The hold time is used for the relays whose switching off cannot be controlled anymore. A sufficiently long enought hold time will make sense. A relay is only held for the set time when off control is disabled.
*Further help under Relays (actuators)
Dead time
Waiting time in milliseconds before the PBX sends DTMF sequences to the door terminal again. Possible entries: 0 to 10000 milliseconds. Time settings for receiving DTMF sequences again are to be made in accordance with the instructions of the connected devices.
*Further help under Relays (actuators)
Switching | Switch on
Settings of the required DTMF sequences in order to switch on an analogue relay. Possible entries: Digits and the characters * and # and the comma ',' character as a pause of half a second.
*Further help under Relays (actuators)
Switching | Switch off
Settings of the required DTMF sequences in order to switch off an analogue relay. Possible entries: Digits and the characters * and # and the comma ',' character as a pause of half a second.
*Further help under Relays (actuators)
Close
The dialogue for the configuration is closed, already created data is discarded.
Save and close
The dialogue for the configuration is closed, already created data is saved.