Conference call
All the options listed above are for a conference call that you have initiated yourself.
Initiating a call
Scenario:
• there is an existing connection between you and at least two other subscribers.
Press the Conf. soft key.
Further help under Conference callsSplitting a call
To do this, select the required subscriber > press OK
Note: If you press the Conf. soft key several times, you restore the conference call. Further help under Conference callsConnecting the other two conference call partners to each other
Press the Join soft key.
Further help under Conference callsSplitting a conference call
Press the Split soft key.
One subscriber is put on hold and there is an active connection with the other subscriber. You can change between holding a call and an active call.
Press Hold to do this.
Further help under Conference callsHolding a conference call and initiating an additional call
Select the conference call > press Hold > press the Dial soft key > press OK
The conference call partners are put on hold and hear the "music on hold".
When the call ends, you can continue the conference call by pressing Hold again.
Further help under Conference callsEnding a call with a conference call partner
Select the subscriber for whom you want to close the connection > press the End soft key.
Then, there will only be a connection with the remaining subscriber.
Further help under Conference callsEnding a conference call completely
To do this, hang up the receiver
or
select Conference > press the End soft key
Further help under Conference calls