Service data
In case of a malfunction of the PBX, a log can be recorded. This can then be forwarded to the specialised departments (Serice, Development) for troubleshooting. The following protocol options are available:
Recording a network trace in PCAP format to control the network data stream
Logging of the control and management information of the PBX connections
in PCAP format e.g. via the PC programme Wireshark
via a syslog server
In addition, Ping can be used to check if the PBX has an existing network connection.
Data protection for network diagnosis trace
*Important: Note the following legal notes prior to recording a network data stream.
The recorded network data stream may contain the following components:
Data streams of other computers in the network
Connection data sets with destination, source, and time information of a telecommunication connection
The spoken word of both ends of a telecommunication connection
Configuration data of the PBX and connected phones, as well as the corresponding PINs and passwords
Before the backup is being saved, all users to the PBX must be informed that these contents will be forwarded and about who will use the data received. It is essential to store the data securely and in accordance with the legal requirements. If you want to make the backup available to your specialised dealer or to the manufacturer for error analysis, you must make sure that the legal requirements are fulfilled.
Network diagnosis trace process
Requirements:
Pop-up blocker which is disabled in the browser or a defined exception rule
1.Start the trace under Administration > Service > Network Diagnosis > > Start Trace.
2.If the malfunction can easily be reproduced, try to trigger it.
3.Finish the trace by clicking Stop Trace.
4.Save the file.
*Please refer for evaluation to Auerswald Support/FONtevo Support.
Data protection for logging
*Important: Please note the following legal information before approval: After activation, any computer in the LAN can read and record the log records of the PBX from the time of activation without any further password protection.
The log records can contain the following components:
Connection data sets with destination, source, and time information of a telecommunication connection
Configuration data of the PBX and connected phones, as well as the corresponding PINs and passwords
Address books of the PBX
Before any recording, all users in the telecommunication connection must be informed that these contents will be recorded and must also be informed who will use the recorded data. If you want to make the recorded data available to your specialised dealer or to the manufacturer for error analysis, you must make sure that the legal requirements are fulfilled.
Process for logging in PCAP format (here with Wireshark)
Requirements:
Logging activated for logging systems that support PCAP format
Administration > Service > Logging > Logging activated/Logging system
Installed PC programme Wireshark
1.Start the command line.
2.Enter the following:
start wireshark -k -i TCP@IP address:Port
The PBX's IP address:IP address
Port for logger output in Wireshark:Port
Example: start wireshark -k -i TCP@192.168.0.240:42231
3.Click Enter.
4.Wireshark starts the logging.
*Note: The log output by Wireshark is coded.
*Please refer for evaluation to Auerswald Support/FONtevo Support.