Help > Using the web interface > Administration > E-mail > Outgoing mail server
Outgoing mail server
Outgoing Mail Server (SMTP)
Select the outgoing mail server to be displayed/configured.
*Further help under E-mail
Default outgoing mail server
The selected outgoing mail server is used as default.
*Note: The outgoing mail server first configured in the PBX is automatically switched on. To switch on another outgoing mail server, the currently switched on outgoing mail server must first be switched off.
*Further help under E-mail
Name
Freely selectable name. This name is used to identify the outgoing mail server within the PBX and from connected phones.
*Further help under E-mail
Address
Enter the address of the outgoing mail server:
IPv4 address
Four blocks separated by a dot (.).
IPv6 address
Eight blocks separated by a colon (:).
*Further help under E-mail
Port (1..65535)
Requirements:
Knowledge of the access data for the outgoing mail server
Enter the port number of the outgoing mail server between 1 up to 65535. You can obtain the port number from your e-mail provider or read it up in the Internet.
*Further help under E-mail
Encryption (SSL)
If encryption is enabled, the connection of the outgoing mail server is secured using the SSL (Secure Socket Layer) protocol. The data is transferred via https.
No encryption
Switches encryption off.
Encryption (SSL) after STARTTLS
Switches encryption on after STARTTLS.
Encryption (SSL) immediately
Switches encryption immediately on.
*Further help under E-mail
Type of authentication
No authentication
Disables authentication.
User name / Password (AUTH PLAIN)
Enables authentication via user name/password.
User name / Password (AUTH LOGIN)
Enables authentication via user name/password.
MD5 challenge-response (AUTH CRAM-MD5)
Enables authentication via MD5 challenge-response (MD5 = Message-Digest Algorithm 5).
automatically
The authentication type is set automatically.
*Further help under E-mail
User name
Requirements:
Enabled authentication
Enter the user name. In the most cases, this is your e-mail address.
*Further help under E-mail
Password
Requirements:
Enabled authentication
Enter the password that belongs to the user name.
*Important: Space and the following special characters are currently not supported: ! @ # $ % ^ &
*Further help under E-mail
Sender
Enter the address of the e-mail sender. It is used to display it to the recipient of the e-mails.
*Further help under E-mail
New
Creates a new entry.
*Further help under E-mail
Delete
Deletes the entries marked in the list.