Buch1 > Functions, Uses, Concepts > Ringing Sequence > Explanations of the Ringing Sequence
Explanations of the Ringing Sequence
Different ringing sequences can be set, as it does not always make sense that all phones logged in a group (e. g. in hotline mode) ring at the same time.
The following ringing sequences are possible:
All
•All subscribers logged into the group ring simultaneously (except fixed phones)
•Call waiting is applied to all logged-in phones when they are busy
•The call is ended by the network provider (after approx. 2 minutes)
•In the case of call forwarding on no reply, the group call is forwarded to the destination already after the configured delay time
Linear
•All phones logged into a group ring directly one after the other
•Only one phone rings at a time
•Busy subscribers are skipped
•In the case of call forwarding on no reply, the group call is forwarded to the destination already after the configured delay time
Adding
•All subscribers logged into a group ring one after the other delayed by the specified time
•Busy subscribers are skipped
•In the case of call forwarding on no reply, the group call is forwarded to the destination already after the configured delay time


The following properties can additionally be selected for the ringing sequence, whereby the ringing sequence All restricts the selection for further properties.
fixed
The order phones are called depends on the assigned priority.
balancing
The order of the called phones depends on a dynamic priority list. After each call, the phone involved is placed last.
rotating
After the first loop, another one starts. In the second loop, call waiting is applied to the busy subscribers. The call is ended by the network provider (after approx. 2 minutes).
without rotating
After the first loop, the call is disconnected.
Split Group
During the ringing pahse, the group must be available for other callers. The group is split up so that as many subscribers as possible are available for each call.
without Split Group
A second caller hears the busy signal while the first caller has not been accepted yet (only possible for All).
Proceed as follows for configuration:
•Configuring ringing sequence, priority and ringing delay for the existing groups.
−Using the Configuration Manager (Groups > Properties > Basic settings)
•If necessary, configuring rework time for the existing groups.
−Using the Configuration Manager (Groups > Properties > Reachability)